Burkert FLOWave L - Page 297

297
Outputs – Parameter
Type 8098 FLOWave L

→ Go to the CONFIGURATION view.
→ Outputs
→ Parameter view.
→ Output2:digital or Output3:digital
→ Mode
→ Pulse
→ Settings The Currentsettings are displayed
→ Enabled
→  
→  
→ pulse/volume or volume/pulse in the wanted volume units
or
→ pulse/mass or mass/pulse in the wanted mass units
→  pulse/volume, set the number of pulses to be transmitted on the digital


→  volume/pulse
the digital output
→  pulse/mass, set the number of pulses to be transmitted on the digital output


→  mass/pulse
digital output
→ 
→  The Newsettings are displayed.
→ 

English