Burkert FLOWave L - Page 152

152
SAW sensor – Parameter
Type 8098 FLOWave L
→ Low, Medium or High, you can set your own
.
None damping: all

measured values are
transmitted
Low damping Medium damping High damping
Chosen damping level is applied

 
 
Dampinglevel Responsetime
None
• Refreshtime is set to Long
• Refreshtime is set to Short or Veryshort.
 
 
 
Special
Responsetime

→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Volumeow
→ Damping The Currentsettings are displayed
→ Low, Medium and High The Newsettings are
displayed.
→ 

English