Burkert FLOWave L - Page 53

53
Electrical installation
Type 8098 FLOWave L
WARNING
Riskofinjuryduetonon-conforminginstallation.
▶ 
the appropriate tools.
▶ Fit a circuit breaker or a switch to the electrical installation of the building in which the device is
installed.
▶ Install the circuit breaker or the switch in an easily accessible place.
▶ Identify the circuit breaker or the switch as the disconnecting component for the electrical power supply
to the device.
▶ Install overload devices that are appropriate for electrical installation.
▶ 
WARNING
Riskofinjuryduetounintentionalswitchonofthepowersupplyoruncontrolledrestartoftheinstallation.
▶ Take appropriate measures to avoid unintentional activation of the installation.
▶ Guarantee a set or controlled process restart after carrying out any intervention on the device.
CAUTION
Riskofinjuryduetoaheavydevice.
A heavy device can fall down during transport or during installation and cause injuries.
▶ Transport, install and dismantle a heavy device with the help of another person.
▶ Use appropriate tools.
NOTICE
Thedevicewillbedamagedifyouuseatooltoturntheblindcoverorthedisplaymodule.
▶ Do not use a tool to turn the blind cover or the display module.
NOTICE
IfyoutrytoremovethenutfromastainlesssteelM20x1.5cablegland,thedeviceisnolongertight.
▶ 
cable gland cannot be removed.
▶ Turn the nut until the stop. If you turn beyond the stop, the cable gland unscrews from the device and
the device is no longer tight.
NOTICE
Ifthescrewedplugofa5-pinM12maleconnectorisremoved,thedeviceisnottight.
▶ 
▶

English