2-34 Service Manual
7510
981.00
Service finisher
error
Sensor (stacker bin level 1)
late error
Sensor (stacker bin level 2)
late error
The sensing area of the sensor (stacker bin level 1)
or Sensor (stacker bin level 2) is not interrupted
within the specified period after the stacker bin
starts rising.
Refer to the Finisher Service Manual.
981.01
Service finisher
error
Stacker bin upper limit error The sensing area of the sensor (stacker bin upper
limit) is not interrupted when the stacker bin raises
to its uppermost limit.
Refer to the Finisher Service Manual.
981.02
Service finisher
error
Stacker bin lower limit error The stacker bin lowers beyond the specified lower
limit within the specified time.
Refer to the Finisher Service Manual.
982.00
Service finisher
error
Sensor (front tamper HP) late
error
The sensing area of the sensor (front tamper HP) is
not interrupted when the front tamper starts moving
to the home position.
Refer to the Finisher Service Manual.
982.01
Service finisher
error
Sensor (front tamper HP) lag
error
The sensing area of the sensor (front tamper HP)
remains interrupted within the specified time after
the front tamper starts moving from the home
position.
Refer to the Finisher Service Manual.
983.00
Service finisher
error
Sensor (rear tamper HP) late
error
The sensing area of the sensor (rear tamper HP) is
not interrupted when the rear tamper starts moving
to the home position.
Refer to the Finisher Service Manual.
983.01
Service finisher
error
Sensor (rear tamper HP) lag
error
The sensing area of the sensor (rear tamper HP)
remains interrupted within the specified time after
the rear tamper starts moving from the home
position.
Refer to the Finisher Service Manual.
984.00
Service finisher
error
Sensor (punch unit HP) late
error
The sensing area of the sensor (punch unit HP) is
not interrupted during the specified time after the
punch unit starts moving to the home position.
Refer to the Finisher Service Manual.
984.01
Service finisher
error
Sensor (punch unit HP) lag
error
The sensing area of the sensor (punch unit HP)
remains interrupted within the specified time after
the punch unit starts moving from the home
position.
Refer to the Finisher Service Manual.
985.00
Service finisher
error
Sensor (punch carriage shift
HP) late error
The sensing are of the sensor (punch carriage shift
HP) is not interrupted within the specified time after
the punch carriage starts moving to the home
position.
Refer to the
Finisher Service Manual.
985.01
Service finisher
error
Sensor (punch carriage shift
HP) lag error
The sensor (punch carriage shift HP) remains
interrupted within the specified time after the punch
carriage starts moving from the home position.
Refer to the Finisher Service Manual.
Error code or
message
Error contents Description/Action
To Next Page
Loading...
Need help?
General
