Lexmark X945e MFP 7510 series User Manual

I-2 Service Manual
7510
Go Back
Previous
Next
Power-on Reset sequence 2-2
Diagnostic Menus
entering diagnostic menus
3-2
diagnostics
error code table
2-13
Diagnostics Menus
available tests
3-2
BASE SENSOR TEST 3-15
DEVICE TESTS 3-16
Disk Test/Clean 3-17
Quick Disk Test 3-16
DUPLEX TESTS
3-9, 3-10
Quick Test 3-9
EVENT LOG 3-20
Clear the Event Log 3-22
Display the Event Log 3-21
Print the Event Log 3-22
FINISHER TESTS
Feed Tests
3-13
Hole Punch Test 3-13
Sensor Test 3-13
Staple Test 3-12
HARDWARE TESTS 3-8
Button Test 3-8
CACHE Test 3-9
DRAM Test 3-9
Panel Test 3-8
INPUT TRAY TESTS
Feed Tests
3-10
Sensor Test 3-11
MOTOR TESTS 3-6
OUTPUT TRAY TESTS
Feed Tests
3-11
Feed To All Bins 3-12
Sensor Test 3-12
PRINT TESTS 3-7
PRINTER SETUP 3-18
Configuration ID 3-19
Defaults 3-18
Engine Setting 1 to 4 3-19
Model Name 3-19
Permanent Page Count 3-19
Printed Page Count 3-18, 3-19
Serial Number 3-19
SCANNER TESTS
ASIC Test
3-23
Feed Test 3-23
Scanner Manual Registration 3-24
Scanner manual registration factory defaults 3-33
Sensor Test 3-24
Dial Pause button 2-4
down arrow button 2-10
Duplex 1-79
E
environment 1-1
error codes
200.00 sensor (registration) late jam
2-39
200.01 sensor (registration) lag jam 2-40
200.01 sensor (registration) late jam 2-43
200.01 sensor (registration) static jam 2-42
201.00 sensor (fuser exit) late jam 2-44
202.00 sensor (fuser exit) lag jam 2-46
230.00 sensor (duplex wait) late jam (duplex media
feed)
2-47
231.00 sensor (registration) late jam (duplex feed) 2-49
231.01 sensor (registration) late jam (duplex media
feed)
2-51
241.00 sensor (tray 1 feed-out) late jam 2-53
242.00 sensor (tray 2 feed-out) late jam 2-55
242.01 sensor (tray 1 feed-out) late jam (feeding from
tray 2)
2-56
243.00 sensor (tray 3 feed-out) late jam 2-57
243.01 sensor (tray 2 feed-out) late jam (feeding from
tray 3)
2-59
244.00 sensor (tray 4 feed-out) late jam 2-61
244.01 sensor (tray 3 feed-out) on jam (feeding from
tray 4)
2-63
250.00 sensor (registration) late jam (feeding from the
MPF)
2-64
290.00 switch (sheet through) static jam 2-66
290.01 sensor (sheet through) late jam 2-67
290.02 sensor (ADF pre-registration) late jam (side 1)
2-69
290.03 sensor (ADF pre-registration) lag jam 2-70
290.10 sensor (ADF pre-registration) static jam 2-73
290.11 sensor (ADF registration) late jam (side 1) 2-74
290.12 sensor (ADF registration) late jam (side 2) 2-75
290.13 sensor (ADF registration) lag jam 2-78
290.14 sensor (ADF inverter) late jam (inverting) 2-80
290.15 sensor (ADF registration) lag jam (inverting)
2-82
290.20 Sensor (ADF width APS1), sensor (ADF width
APS2) and sensor (ADF width APS3) static jam
2-85
290.21 sensor (ADF width APS 1) static jam 2-86
290.22 sensor (ADF width APS 2) static jam 2-87
290.23 sensor (ADF width APS 3) static jam 2-88
291.00 sensor (ADF registration) static jam 2-89
291.01 sensor (ADF inverter) lag jam (inverting) 2-89
291.02 sensor (ADF inverter) late jam 2 2-91
291.03 sensor (ADF inverter) lag jam 2-93
292.01 ADF raised jam 2-95
292.02 ADF left cover jam 2-95
293.00 Document missing jam 2-95
294.00 sensor (ADF inverter) static jam 2-96
294.01 sensor (ADF pre-registration) late jam (side 2)
2-97
294.02 sensor (ADF pre-registration) lag jam (inverting)
2-99
295.00 size mismatch jam (mix-size) 2-102
295.01 size mismatch jam (no mix-size) 2-104
295.02 invalid combine size jam 2-105
295.03 too short size jam 2-106
295.04 too long size jam 2-107, 2-109
295.05 mixed size not supported 2-109
841.00 image pipeline ASIC failure 2-109
842.00 scanner communication failure 2-110

Lexmark X945e MFP 7510 series Specifications

General

Brand	Lexmark
Model	X945e MFP 7510 series
Category	Printer
Language	English