Programming Manual May 2003
Line Key Selection for Tenant Mode 1 - 257
A6-324000-642-02 - Release 6.0
May 2003
3 Press the corresponding CO/PBX line key to change the data option.
The operation data includes:
Setting Data
Note: The following are used when entering data:
J to moves the cursor left
L to moves the cursor right
K~I to enter the numeric data
R to go to the next Tenant No.
Default Values
4 Press CO/PBX LK7; TKGP is displayed.
5 Enter
K E (for RT 05) using the dial pad.
6 Press
N; data of CO/PBX LK 01~24 is displayed successively.
7 After entering data for CO/PBX LK24, press
N to write the data.
8 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
2-05
Line Key Selection
Programming Procedures
Line Key Setting Data (1) LCD Indication Setting Data (2)
1 Not Specified NON N/A
2 CO CO 01~64
3 CFW - BNA FW BNA N/A
4 CFW - ALL FW ALL N/A
5 Call Appearance
Block (00~47)
C Call Appearance
Key 01~24
6 Feature Access FA 01~10
(01~16 if main
software Release 4
and above)
7 Trunk Group TKGP 01~32
8 Route Advance ADV 01~16
9 SIE/CAR
Key
SIE Telephone
Port No.
01~C0
10 Microphone MIC N/A
11 Headset H SET N/A
12 Scroll Key SCROLL N/A
13 DND On/Off DND N/A
14 Log On/Off LOG N/A
15 BGM On/Off BGM N/A
16 Intercom Key ICM N/A
Line
Keys
Tenant
00
Tenant
01~47
01~08 CO/PBX lines 01~08 Not assigned
09~24 Not assigned Not assigned
To Next Page
Loading...
Need help?
General
