NEC Business Solutions Ltd Xen Master & Xen Axis
1 - 258 Line Key Selection for Tenant Mode
A6-324000-642-02 - Release 6.0
May 2003
N
1. Specify Call Appearance as the call appearance number of Call Appearance Block numbers from Memory Block 4-44
Station to Call Appearance Block Assignment.
2. Use this Memory Block to assign the following functions to each of the CO/PBX line keys on each telephone in a
tenant specified as Tenant Mode in Memory Block 2-05 Line Key Selection:
Not specified (NON)
CO/PBX Line (CO) 01~64
CFW - BNA
CFW - ALL
Call Appearance (C) 00~47, 01~24 (Each Call Appearance Block may have a maximum of 24 Call
Appearance keys).
Feature Access (FA) 01~10
Trunk Group (TKGP) 01~32
Route Advance Block (ADV) 01~16
Secondary Incoming Extension (SIE) / Call Arrival Keys (CAR) 0~112
Microphone (MIC)
Headset (H SET)
Scroll Key
DND/Break Mode
Log On/Off
BGM On/Off
Intercom Key
3. Use this Memory Block only if Memory Block 2-05 is set to “Tenant Mode”.
To Next Page
Loading...
Need help?
General
