NEC Business Solutions Ltd Xen Master & Xen Axis
1 - 12 Multiline Terminal Programming
A6-324000-642-02 - Release 6.0
May 2003
57 CO/PBX Prepause Timer Selection 3 sec. None, 1 sec. ~ 13 sec.
59 Synchronous Ringing Selection Yes Yes, No
60 8-Digit Matching Table Assignment Refer to 8-Digit Matching Table Assignment on page 1-90.
61 8-Digit Matching Table to Class
Assignment
Refer to 8-Digit Matching Table Assignment on page 1-90.
62 System Speed Dial Override by Class
Selection
Override (YS) No = No Override
Yes = Override
63 Hold Recall Time Selection (Exclusive) 1 min. 0.5 min., 1 min., 1.5 min., 2 min., 3 min.,
5 min., 8 min., No Limit
64 Attendant Add-On Console Transfer/
Camp-On Recall Timer Selection
1 min. 0.5 min., 1 min., 1.5 min., 2 min., 3 min.,
5 min., 8 min., 10 min.
65 Code Restriction Class Allow/Deny
Selection
Class 01 = Deny
Class 02 ~ 14 Allow
(YS)
Allow, Deny
66 8-Digit Matching Table to Normal Dial
Assignment
Tables 00 ~ 15 = Used
Table 15 = Unused
Used, Unused
67 OCC Table Assignment Not Specified 0~9, *, X, P, N
68 8-Digit Matching Table to OCC Table
Assignment
Table 00~15 = All Not
Used
Table 16 = 00~14 Not
Used, 15 Used
8-digit Matching Table Used or Not Used
69 Tie Line Code Restriction Assignment (YS) Restriction No = No Restriction
Yes = Restriction
70 Code Restriction Class Assignment
when Lockout is Set
Class 01 Restriction Class: 00 ~ 15
71 First Delay Announcement Start Time
Selection
20 sec. 0 sec., 10 sec., 20 sec., 30 sec., 40 sec.,
50 sec., 60 sec.
72 First Delay Announcement Repeat
Selection
1 Time 1, 2, 3, 4, 5, 6, 7, 8 times
73 First to Second Delay Announcement
Interval Time Selection
20 sec. 0 sec., 10 sec., 20 sec., 30 sec., 40 sec.,
50 sec., 60 sec., No Limit
74 Second Delay Announcement Repeat
Selection
1 Time 1, 2, 3, 4, 5, 6, 7, 8 times
75 Second Delay Announcement Repeat
Interval Time Selection
20 sec. 0 sec., 10 sec., 20 sec., 30 sec., 40 sec.,
50 sec., 60 sec., No Limit
77 Delayed Ringing Timer Assignment
(CO)
15 sec. 00 ~ 99
78 Caller ID Display Assignment for
System Mode
Not Specified Combination No = 1~5
Selectable Tel No = 1~20
LK 1 System Mode
LK 1 CO Line (Continued)
Data
No.
Memory Block Name Default Value Programming Values
To Next Page
Loading...
Need help?
General
