NEC Xen Master Programming Manual

May 2003
Programming Manual 1 - 27
A6-324000-642-02 - Release 6.0 May 2003
93 Internal Zone Paging Selection No No
Zone A
Zone B
Zone C
94 3-Minute Alarm Selection No No, Yes
95 DTMF/DP SLT Type Selection DTMF DP, DTMF
96
??? 95 is last data no. (17/01/03) ???
LK 4 Telephone Mode (Continued)
Data
No.
Memory Block Name Default Value Programming Values
LK 5 Trunk Group Mode
Data
No.
Memory Block Name Default Value Programming Values
00 Digit Add/Del for Tie Line Networking No Add and Delete =
000
Delete up to two digits
Add up to two digits
01 Tie Line Networking Tandem
Connection Assignment
All Trunk Groups = Yes On = Yes (Enabled)
Off = No (Disabled)
02 8-Digit Matching Table to Trunk Group
Assignment
Enabled On = Use (Enabled)
Off = Not Used (Disabled)
03 OCC Table to Trunk Group Assignment Use All Tables On - Use (Enabled)
Off = Not Used (Disabled)
LK 6 Copy Mode
Data
No.
Memory Block Name Default Value Programming Values
2 Tenant Mode Copy Assignment N/A Tenant 00~47
3 CO Line Mode Copy Assignment N/A Tenant 01~64
4 Telephone Mode Copy Assignment N/A Tenant 01~120
5 Trunk Group Mode Copy Assignment N/A Tenant 01~32

NEC Xen Master Specifications

General

Brand	NEC
Model	Xen Master
Category	Telephone
Language	English