Schweitzer Engineering Laboratories SEL-751 - Page 406

SET.34
of 78
SEL-751 Settings Sheets Date________________
Global Settings (SET G Command) Group Selection
SEL-751 Relay Instruction Manual Date Code 20170927
Group Selection
LEA Phase Voltages
(The following LEA phase voltage settings are shown if Slot Z := Lx)
MESSENGER POINT MP26 TRIGGER (OFF, 1 Relay Word bit) MPTR26 :=
MESSENGER POINT MP26 AQ (None, 1 analog quantity) MPAQ26 :=
MESSENGER POINT MP26 TEXT (148 characters) MPTX26 :=
MESSENGER POINT MP27 TRIGGER (OFF, 1 Relay Word bit) MPTR27 :=
MESSENGER POINT MP27 AQ (None, 1 analog quantity) MPAQ27 :=
MESSENGER POINT MP27 TEXT (148 characters) MPTX27 :=
MESSENGER POINT MP28 TRIGGER (OFF, 1 Relay Word bit) MPTR28 :=
MESSENGER POINT MP28 AQ (None, 1 analog quantity) MPAQ28 :=
MESSENGER POINT MP28 TEXT (148 characters) MPTX28 :=
MESSENGER POINT MP29 TRIGGER (OFF, 1 Relay Word bit) MPTR29 :=
MESSENGER POINT MP29 AQ (None, 1 analog quantity) MPAQ29 :=
MESSENGER POINT MP29 TEXT (148 characters) MPTX29 :=
MESSENGER POINT MP30 TRIGGER (OFF, 1 Relay Word bit) MPTR30 :=
MESSENGER POINT MP30 AQ (None, 1 analog quantity) MPAQ30 :=
MESSENGER POINT MP30 TEXT (148 characters) MPTX30 :=
MESSENGER POINT MP31 TRIGGER (OFF, 1 Relay Word bit) MPTR31 :=
MESSENGER POINT MP31 AQ (None, 1 analog quantity) MPAQ31 :=
MESSENGER POINT MP31 TEXT (148 characters) MPTX31 :=
MESSENGER POINT MP32 TRIGGER (OFF, 1 Relay Word bit) MPTR32 :=
MESSENGER POINT MP32 AQ (None, 1 analog quantity) MPAQ32 :=
MESSENGER POINT MP32 TEXT (148 characters) MPTX32 :=
GRP CHG DELAY (0–400 s) TGR :=
SELECT GROUP1 (SELOGIC) SS1 :=
SELECT GROUP2 (SELOGIC) SS2 :=
SELECT GROUP3 (SELOGIC) SS3 :=
SELECT GROUP4 (SELOGIC) SS4 :=
VA RATIO CORRECT (0.500–1.500) VARCF :=
VB RATIO CORRECT (0.500–1.500) VBRCF :=
VC RATIO CORRECT (0.500–1.500) VCRCF :=
VA ANGLE CORRECT (-10.0 to 10.0 deg) VA PA C : =
VB ANGLE CORRECT (-10.0 to 10.0 deg) VBPAC :=
VC ANGLE CORRECT (-10.0 to 10.0 deg) VCPAC :=