Schweitzer Engineering Laboratories SEL-751 - Page 416

SET.44
of 78
SEL-751 Settings Sheets Date________________
SET PORT p (p = F, 1, 2, 3, or 4) Command Control Configuration
SEL-751 Relay Instruction Manual Date Code 20170927
Control Configuration
SET PORT p (p = F, 1, 2, 3, or 4) Command
PORT F
Communications
Modbus
PORT 1
(Ethernet Port in Slot B; hidden if the Ethernet option is not included)
(IP addresses are entered using zzz = 1–126, 128–223; yyy = 0–255; xxx = 0–255; www = 0–255)
DISC 2 N/C CONT (SEL
OGIC) 89B2P2 :=
DISC 2 ALM PU (0.00–300.00 sec) 89A2P2D :=
DISC 3 N/O CONT (SELOGIC) 89A2P3 :=
DISC 3 N/C CONT (SELOGIC) 89B2P3 :=
DISC 3 ALM PU (0.00–300.00 sec) 89A2P3D :=
DISC 4 N/O CONT (SELOGIC) 89A2P4 :=
DISC 4 N/C CONT (SELOGIC) 89B2P4 :=
DISC 4 ALM PU (0.00–300.00 sec) 89A2P4D :=
DISC 5 N/O CONT (SELOGIC) 89A2P5 :=
DISC 5 N/C CONT (SELOGIC) 89B2P5 :=
DISC 5 ALM PU (0.00–300.00 sec) 89A2P5D :=
ENABLE LOC REM CON (Y, N) EN_LRC :=
LOCAL CONTROL (SELOGIC) LOCAL :=
ENABLE PORT (Y, N) EPORT :=
PROTOCOL (SEL, MOD, EVMSG, PMU) PROTO :=
MAXIMUM ACCESS LEVEL (1, 2, C) MAXACC :=
SPEED (300, 1200, 2400, 4800, 9600, 19200, 38400 bps) SPEED :=
DATA BITS (7, 8 bits) (Hidden if PROTO := MOD, EVMSG, or PMU) BITS :=
PARITY (O, E, N) (Hidden if PROTO := EVMSG or PMU) PARITY :=
STOP BITS (1, 2 bits) (Hidden if PROTO := MOD or EVMSG) STOP :=
PORT TIME-OUT (0–30 min) (Hidden if PROTO := MOD, EVMSG, or PMU) T_OUT :=
HDWR HANDSHAKING (Y, N) (Hidden if PROTO := MOD or EVMSG) RTSCTS :=
LANGUAGE (ENGLISH, SPANISH) LANG :=
SEND AUTOMESSAGE (Y, N) (Hidden if PROTO := MOD, EVMSG, or PMU) AUTO :=
MODBUS SLAVE ID (1–247) (Hidden if PROTO := SEL, EVMSG, or PMU) SLAVEID :=
ENABLE PORT (Y, N) EPORT :=
IP ADDRESS (zzz.yyy.xxx.www) IPADDR :=