Phaser 7500 Printer Service Manual 3-95
Error Messages and Codes
ATS/ APS No Destination Error
The paper specified for printing cannot be detected.
Applicable Chain-Link Code
• 024-966: ATS/APS No Destination Error, APS/ATS NG (Other Than No Paper)
Initial Actions
• Inspect the tray to ensure that it is free of obstructions, is loaded with
supported paper, and the Guides are adjusted correctly.
• If the problem persists, follow the procedure below.
1. Change the settings or replace the tray.
2. If the problem persists, refer to the “General Sensor Failure” on page 3-28 to
check the sensor.
3. If the problem still persists, perform the “Common System Fail” on page 3-22.
Troubleshooting Reference
Applicable Parts Wiring and Plug/Jack Map References
To Next Page
Loading...
