Xerox PHASER 7500 Service Manual

Phaser 7500 Printer Service Manual 3-205
Error Messages and Codes
Tray 5 Lift Up Fail
Tray 5 Lift Up error has occurred.
Applicable Chain-Link Codes
• 074-210: #5 Lift Up Fail 3 Times in a Row
• 074-940: #5 Lift Up Fail
Initial Actions
• Power cycle the printer.
• If the problem persists, follow the procedure below.
Troubleshooting Reference
Applicable Parts Wiring and Plug/Jack Map References
■ Tray 3/4/5 Feed/Lift Up Motor,
PL10.3.3
■ Tray Module PWB, PL10.9.1
■ MCU PWB, PL18.3.6
■ Motor Drive PWB, PL18.3.7
■ TM Relay PWB, PL18.3.11
Troubleshooting Procedure
Step Actions and Questions Yes No
1 Remove Tray 5.
Perform the Paper Feed Motors
test in Diagnostics.
Does the Tray 5 Feed/ Lift Up
Motor rotate?
Go to step 5. Go to step 2.
2 Is the voltage between the Tray
Module PWB J541-10 (+) and the
GND (-) +24VDC?
Go to step 3. Go to “+24 VDC
Power” on
page 4-16 for
troubleshooting
procedure.

Xerox PHASER 7500 Specifications

General

Max Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	150, 000 pages
Standard Paper Capacity	550 sheets
Duplex Printing	Optional
Standard Memory	256 MB
Network Connectivity	10/100/1000Base-T Ethernet
Supported Operating Systems	Windows, Mac OS, Linux
Max Paper Capacity	2, 100 sheets
Connectivity	USB 2.0, Ethernet
PDL	PostScript 3, PCL 6, PDF
Print Speed	Up to 35 ppm