Phaser 7500 Printer Service Manual xxvii
Moving the Printer
Parts of the printer are hot. Wait at least 30 minutes for the printer to cool
before moving or packing the printer.
• Use the power switch to turn Off the printer, and unplug all cables and cords.
Do not turn the printer Off by pulling the power cord or using a power-strip
with an On/Off switch.
Back injury could result if you do not lift the printer properly.
• The printer is heavy and must be lifted by three people. Use safety lifting and
handling techniques when moving the printer.
When shipping the printer, repack the printer using the original packing material
and boxes or a Xerox packaging kit. Instructions for repacking the printer are
included in the kit. If you do not have all the original packaging, or are unable to
repackage the printer, contact your local Xerox service representative.
Failure to repackage the printer properly for shipment can result in damage to
the printer. Damage to the printer caused by improper packaging is not
covered by the Xerox warranty, service agreement, or Total Satisfaction
Guarantee.
To Next Page
Loading...
