Phaser 7500 Printer Service Manual 8-165
Service Parts Disassembly
REP 14.15 Inner Chute Assembly
PL14.5.19
1. Remove the Duplex Assembly (REP 14.12, page 8-161).
2. Release the 3 hooks that secure the Sensor Cover to the Duplex Assembly and
remove the Sensor Cover.
3. Disconnect the wiring harness connector that is connected to the Duplex Wait
Sensor.
4. Release the wiring harness from the 3 hooks on the Inner Chute Assembly and
move it towards the Duplex Motor side.
5. Remove 2 screws (silver, Tapped, 8mm) that secure the Motor Cover to the
printer.
6. Release the Motor Cover from the protrusion of the Inner Chute Assembly and
remove the Motor Cover.
7. Remove 5 screws (silver, Tapped, 8mm) that secure the Inner Chute Assembly
to the Duplex Assembly.
8. Remove the Inner Chute Assembly from the Duplex Assembly.
s7500-225
Motor Cover
Sensor Cover
To Next Page
Loading...
