Xerox PHASER 7500 - REP 11.13 Handle; Latch; Hook

Phaser 7500 Printer Service Manual 8-123
Service Parts Disassembly
REP 11.13 Handle/ Latch/ Hook
PL11.6.9/ PL11.6.10/ PL11.6.11
1. Remove the Left Cover-STM (REP 11.16, page 8-126).
2. Remove the L/H Cover Assembly-STM (REP 11.12, page 8-122).
3. Unhook the spring from the rib of the L/H Cover-STM.
4. Remove 1 screw (silver, Tapped, 8mm) that secures the hook and remove the
hook.
Note
When pulling out the latch in the following step, you may meet some
resistance at several locations. When that happens, slide the latch sideways
until it stops and rotate it. Once the resistance is gone, slide it further. Repeat
this procedure until it is completely removed.
5. Pull the latch sideways and remove the handle and the spring. Pull the latch all
the way until it is removed.
s7500-184
Hook
Handle
Latch