Phaser 7500 Printer Service Manual 3-131
Error Messages and Codes
ENG_LOGIC_FAIL
Engine internal mismatch (control logic mismatch).
Applicable Chain-Link Code
• 045-313: Drive Logic Fail
Initial Actions
• Power cycle the printer.
• If the problem persists, follow the procedure below.
1. Turn the power Off and On.
2. Restore NVRAM. If the problem persists, replace the MCU PWB (REP 18.12,
page 8-202).
Troubleshooting Reference
Applicable Parts Wiring and Plug/Jack Map References
■ MCU PWB, PL18.3.6
To Next Page
Loading...
