DHCP (Dynamic Host Configuration Protocol) Client
Left running head:
Chapter name (automatic)
1066
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O ATTACH A DHCP CLIENT OBJECT TO AN INTERFACE
EXAMPLE
ALU(config-if GigabitEthernet3/0)# dhcp client client1
ALU(config-if GigabitEthernet3/0)# no dhcp client client1
Note: At any given point of time, if a DHCP client object attached to an interface is modified,
the changes will not take effect automatically. For this, you need to reattach the DHCP
client object on the interface.
Command (in ICM) Description
dhcp client <client-name> This command is entered in the Interface
Configuration Mode.
This command is used to attach a DHCP
client object on an interface.
no dhcp client <client-name> This command is used to detach the
client object from an interface.
To Next Page
Loading...
