EasyManuals Logo

Alcatel-Lucent OmniAccess 5740 Cli Configuration Guide

Alcatel-Lucent OmniAccess 5740
1225 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #128 background imageLoading...
Page #128 background image
Software Package Management
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
102
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO INSTALL A PACKAGE ON THE SYSTEM
Note: If the package is installed from a remote location, it is temporarily downloaded into the
user area, and deleted after the installation. So care must be taken to have enough
space for the package before proceeding with the installation.
E
XAMPLE
The following command installs a package after downloading it from remote site
using ftp:
ALU(config)# package install ftp:
Remote Host : 10.91.0.87
Remote Port [ Enter for default ] :
Path/Filename : /packages/alu-apps.740.3.0.0.82.0.npm
Username [Enter for none] : user1
Password :
Downloading remote file. This could take a while...
Verifying package... NPM v1.0 format
OK.
Checking the package type ... Release: 3.0.0.82.0
Are you sure you want to install alu-apps.740.3.0.0.82.0.npm?
(y/[n]) : y
Installing new release alu-apps.740.3.0.0.82.0.npm...OK.
Complete.
Deleting temporary file...OK.
Do you want to set-default immediately?
Yes: Chassis will be rebooted automatically
No : Manually run set-default at a later time
Proceed? (y/[n]) : y
Do you want to save config before proceeding ([y]/n) : y
Building configuration...
[OK]
Setting Default image to 3.0.0.82.0...
Command (in CM) Description
package install
{fpkey:|ftp:|http:|https:
|tftp:|user:|vrf <vrf-
name>}
Installs a release or a component package
from the given location. The package file can
be obtained from user area or fpkey: or it can
be obtained from a remote site using FTP,
TFTP, HTTP, HTTPS, or through an interface
associated with the specified VRF.
package install flash
{fpkey:|ftp:|http:|https:
|tftp:|user:|vrf <vrf-
name>}
Installs a LoL flash image on all the cards. The
package file can be obtained from user area or
or fpkey: it can be obtained from a remote site
using FTP, TFTP, HTTP, HTTPS, or through an
interface associated with the specified VRF.

Table of Contents

Other manuals for Alcatel-Lucent OmniAccess 5740

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent OmniAccess 5740 and is the answer not in the manual?

Alcatel-Lucent OmniAccess 5740 Specifications

General IconGeneral
BrandAlcatel-Lucent
ModelOmniAccess 5740
CategoryGateway
LanguageEnglish

Related product manuals