Frame Relay
Left running head:
Chapter name (automatic)
324
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE THE LMI KEEPALIVE VALUE
Enter this command in the Interface Configuration mode.
The LMI keepalive value should typically be equal to the corresponding interval at
the switch.
E
XAMPLE
The following example sets the LMI keepalive interval to 12:
ALU(config-if Serial0/0:0)#frame-relay keepalive 12
ALU(config-if Serial0/0:0)# no frame-relay keepalive
T
O SET A FULL STATUS POLLING INTERVAL
Enter this command in the Interface Configuration mode.
E
XAMPLE
The following example sets the polling interval to 8:
ALU(config-if Serial0/0:0)#frame-relay lmi-n391dte 8
The following example sets the polling interval to default, i.e., 6:
ALU(config-if Serial0/0:0)# no frame-relay lmi-n391dte
Command (in ICM) Description
frame-relay keepalive <0-
32767>
This command is used to configure the
LMI Keepalive interval.
The default LMI Keepalive value is 10.
no frame-relay keepalive The “no” command resets the LMI
Keepalive interval to ‘0’.
Command (in ICM) Description
frame-relay lmi-n391dte <1-
255>
This command is used to set the full
status polling interval on a DTE
interface.
no frame-relay lmi-n391dte The “no” command sets the polling
interval to its default value.
The default polling interval is 6.
To Next Page
Loading...
Need help?
General
