Alcatel-Lucent OmniAccess 5740 - Page 368

Point-to-Point Protocol
Left running head:
Chapter name (automatic)
342
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O SET TIMEOUT MAX-CONFIGURE
E
XAMPLE
ALU(config-if Serial0/0:0)# ppp timeout max-configure 15
ALU(config-if Serial0/0:0)# no ppp timeout max-configure
T
O SET TIMEOUT MAX-FAILURE
E
XAMPLE
ALU(config-if Serial0/0:0)# ppp timeout max-failure 10
ALU(config-if Serial0/0:0)# no ppp timeout max-failure
Command (in ICM) Description
ppp timeout max-configure <1-30> This command sets the maximum
number of configure request packets
(LCP or NCP) sent without receiving a
valid Ack/NaK/Reject, before
assuming that the peer is unable to
respond.
no ppp timeout max-configure The “no” command sets the max-
configure value to its default.
The default max-configure value is
“10”.
Command (in ICM) Description
ppp timeout max-failure <1-30> This command sets the maximum
number of configure NaK packets (LCP
or NCP) sent without sending a
Configure Ack before assuming that
configuration is not converging.
no ppp timeout max-failure The “no” command sets the max-failure
value to its default.
The default max-failure value is “5”.