Alcatel-Lucent OmniAccess 5740 - Page 367

PPP Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
341
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
PPP COUNTERS AND TIMERS CONFIGURATION
This section covers the configuration of PPP Timers and Counters.
T
O SET TIMER FOR RETRANSMISSION OF PACKETS
E
XAMPLE
ALU(config-if Serial0/0:0)# ppp timeout restart-timer 13
ALU(config-if Serial0/0:0)# no ppp timeout restart-timer
T
O SET TIMEOUT MAX-TERMINATE
E
XAMPLE
ALU(config-if Serial0/0:0)# ppp timeout max-terminate 10
ALU(config-if Serial0/0:0)# no ppp timeout max-terminate
Command (in ICM) Description
ppp timeout restart-timer <1-30> This command sets a timer for re-
transmission of LCP and NCP
packets.
no ppp timeout restart-timer The “no” command resets the
restart-timer to its default.
The default restart-timer value is “3
seconds”.
Command (in ICM) Description
ppp timeout max-terminate <1-30> This command sets the maximum
number of terminate request
packets (LCP or NCP) sent without
receiving a Terminate Ack, before
assuming that the peer is unable to
respond.
no ppp timeout max-terminate The “no” command sets the max-
terminate value to its default.
The default max-terminate value
is “2”.