Alcatel-Lucent OmniAccess 5740 - Page 374

Point-to-Point Protocol
Left running head:
Chapter name (automatic)
348
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
IN OUT
CHAP Challenges: 0 0
CHAP Responses: 0 0
CHAP Successes: 0 0
CHAP Failures: 0 0
CHAP Invalid Packets: 0 0
IN OUT
EAP Requests: 0 4
EAP Responses: 4 0
EAP Successes: 0 2
EAP Failures: 0 0
EAP Invalid Packets: 0 0
T
O VIEW INTERFACE STATISTICS
EXAMPLE
The following example shows the states for LCP, CHAP Client, EAP Server, and
IPCP in the "show interfaces" output.
ALU(config-if Serial0/0:0)# show interfaces Serial 0/0:0
Serial0/0:0 is up, line protocol is up
Internet address is 100.101.102.103/24
MTU 1200 bytes, BW 1544 Kbit, DLY 0 usec,
reliability 0/255, txload 0/255, rxload 0/255
loopback not set
Encapsulation ppp, Keepalive set (10 sec)
LCP: Open
CHAP Client: Open
EAP Server: Open
IPCP: Open
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue: 0/0 (size/max) 0 drops; Input queue: 0/0 (size/max) 0
drops
Conversations: 0/0/0/0 (active/max active/max total)
Reserved Conversations: 0/0 (allocated/max allocated)
Available Bandwidth 1544 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
50 packets input, 0 bytes, 0 no buffer
Command (in SUM/CM/ICM) Description
show interfaces <name> Displays detailed statistics and other
information for a specified interface.