Alcatel-Lucent OmniAccess 5740 - Page 375

PPP Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
349
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
60 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Timeslot(s) Used:1-31, Transmitter delay is 0 flags
PPP LCP SHOW COMMANDS
The following commands are used to view the PPP LCP configuration details, and
statistics:
T
O VIEW THE PPP LCP CONFIGURATION
EXAMPLE
ALU# show ppp lcp configuration Serial 0/0:0
LCP Max Echoes : 5
LCP Echo Interval : 60 (sec)
LCP Restart Interval : 30 (sec)
T
O VIEW THE PPP LCP STATISTICS
EXAMPLE
ALU# show ppp lcp statistics Serial 0/0:0
IN OUT
LCP Configure Requests: 2 2
LCP Configure Acks: 2 2
LCP Configure Naks: 0 0
LCP Configure Rejects: 0 0
LCP Terminate Requests: 0 0
LCP Terminate Acks: 0 0
LCP Code Rejects: 0 0
LCP Protocol Rejects: 0 0
LCP Echo Requests: 2 2
LCP Echo Replies: 2 2
LCP Discard Requests: 0 0
LCP Invalid Packets: 0 0
Command (in SUM/CM/ICM) Description
show ppp lcp configuration
Serial <slot/port:channel>
Displays the PPP LCP configuration
information for a specified interface.
Command (in SUM/CM/ICM) Description
show ppp lcp statistics Serial
<slot/port:channel>
Displays detailed LCP statistics for a
specified interface.