Alcatel-Lucent OmniAccess 5740 - Page 376

Point-to-Point Protocol
Left running head:
Chapter name (automatic)
350
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
PPP IPCP S
HOW COMMANDS
The following commands are used to view the PPP IPCP configuration and
statistics:
T
O VIEW THE PPP IPCP CONFIGURATION
EXAMPLE
ALU# show ppp ipcp configuration Serial 0/0:0
IPCP pool IP address: 50.51.52.54
IPCP local IP address from peer: Reject
IPCP peer IP address: Reject
T
O VIEW THE PPP IPCP STATISTICS
EXAMPLE
ALU# show ppp ipcp statistics Serial 0/0:0
IN OUT
IPCP Configure Requests: 6 13
IPCP Configure Acks: 6 6
IPCP Configure Naks: 5 0
IPCP Configure Rejects: 2 0
IPCP Terminate Requests: 0 2
IPCP Terminate Acks: 2 0
IPCP Code Rejects: 0 0
IPCP Invalid Packets: 0 0
Command (in SUM/CM/ICM) Description
show ppp ipcp configuration
Serial <slot/port:channel>
Displays PPP IPCP configuration
information for a specified interface.
Command (in SUM/CM/ICM) Description
show ppp ipcp statistics
Serial <slot/port:channel>
Displays detailed IPCP statistics for a
specified interface.