Alcatel-Lucent OmniAccess 5740 - Page 433

OAM Configuration on OmniAccess 5740 USG
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
407
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO CONFIGURE MEP (MAINTENANCE ASSOCIATION END POINT)
E
XAMPLE
ALU(config-oam-domain-assoc)# mep 1 direction Down interface
GigabitEthernet 3/0
ALU(config-oam-domain-assoc-mep)#
ALU(config-oam-domain-assoc)# no mep 1 direction Down interface
GigabitEthernet 3/0
T
O ADMINISTRATIVELY BRING UP/DOWN MEP
E
XAMPLE
ALU(config-oam-domain-assoc-mep)# no shutdown
ALU(config-oam-domain-assoc-mep)# shutdown
Command (in OAM-DA CM) Description
mep <1-8191> direction
{Down|Up} interface <name>
[vlan <1-4094>]
This command is used to create a MEP
identifier (MEPID) within a Maintenance
Association.
This enters MEP Configuration Mode.
Note: The MEP (source) should
always be configured in the
Down direction. Down
indicates that the MEP
receives CFM PDUs from,
and transmits them towards
the direction of the LAN.
no mep <1-8191> [direction
{Down|Up} interface <name>
[vlan <1-4094>]]
This command is used to disassociate
the MEP from a MA.
Command (in OAM-DA MEP CM) Description
no shutdown This command is used to
administratively bring up the MEP.
shutdown This command is used to
administratively bring down the MEP.
By default, MEP will be in shutdown
state.