Alcatel-Lucent OmniAccess 5740 - Page 435

OAM Configuration on OmniAccess 5740 USG
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
409
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
CONFIGURE MEP OPTIONAL PARAMETERS
TO CONFIGURE MAC ADDRESS FOR A MEP
By default, MEP takes the interface MAC address as the default address. In order
to differentiate different MEPs on the same physical interface, you can configure
the MAC address for each MEP using the below given command.
E
XAMPLE
ALU(config-oam-domain-assoc-mep)# macaddress 1111.2222.3333
ALU(config-oam-domain-assoc-mep)# no macaddress
T
O CONFIGURE LOWEST PRIORITY FAULT ALARM
Fault alarm is an out-of-band signal, like an SNMP notification that notifies a user
of the connectivity failure.
E
XAMPLE
ALU(config-oam-domain-assoc-mep)# fault-alarm lowest-priority-
defect 1
ALU(config-oam-domain-assoc-mep)# no fault-alarm lowest-
priority-defect
Command (in OAM-DA MEP CM) Description
macaddress <mac-address> This command is used to configure MAC
address for a MEP.
no macaddress [<mac-address>] This command is used to remove the
MAC address configuration from a MEP.
This command sets the MAC address to
the default, that is MEP takes the
interface MAC address as the default
address.
Command (in OAM-DA MEP CM) Description
fault-alarm lowest-priority-
defect <1-6>
This command is used to configure the
lowest priority fault alarm for a MEP.
no fault-alarm lowest-
priority-defect [<1-6>]
This command is used to delete the
configured lowest priority fault alarm
value and reset it to the default.
The default lowest priority defect
value is 2.