Alcatel-Lucent OmniAccess 5740 - Page 436

Ethernet OAM (Operations, Administration, and Maintenance)
Left running head:
Chapter name (automatic)
410
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE TIME INTERVAL FOR FAULT ALARM
EXAMPLE
ALU(config-oam-domain-assoc-mep)# fault-alarm set-time 300
ALU(config-oam-domain-assoc-mep)# no fault-alarm set-time 300
T
O RESET TIME INTERVAL FOR FAULT ALARM
EXAMPLE
ALU(config-oam-domain-assoc-mep)# fault-alarm reset-time 400
ALU(config-oam-domain-assoc-mep)# no fault-alarm reset-time 400
Command (in OAM-DA MEP CM) Description
fault-alarm set-time <250-
1000>
This command is used to specify the
time interval (in milliseconds) after which
the fault alarm is raised for all the defects
detected for a MEP.
no fault-alarm set-time [<250-
1000>]
This command is used to delete the
interval timer settings configured for fault
alarm and reset it to default value.
The default time interval is 250
milliseconds.
Command (in OAM-DA MEP CM) Description
fault-alarm reset-time <250-
1000>
This command configures the fault alarm
reset time (in milliseconds) on a MEP.
During this time interval, no fault alarms
are generated.
no fault-alarm reset-time
[<250-1000>]
This command is used to delete the
configured fault alarm reset time and set
it to default value.
The default reset-time is 1000
milliseconds.