Alcatel-Lucent OmniAccess 5740 - Page 471

LFI Configuration on MLPPP
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
445
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Step 11: Configure fragment delay on the MLPPP bundle interface. See “To
Configure Fragment Delay on the MLPPP Interface”
Step 12: Configure slippage MRU on the MLPPP bundle interface. See “To
Configure Slippage MRU (Maximum Receive Unit) on the MLPPP Interface”
(Optional)
Step 13: Enter Serial interface configuration mode for Member Link Configuration
ALU(config)# interface Serial <slot/port:channel>
ALU(config-if Serial<slot/port:channel>)#
Example:
ALU(config)#interface Serial0/0:0
ALU(config-if Serial0/0:0)#
Step 14: Administratively bring up the interface
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if Serial0/0:0)# no shutdown
Step 15: Set MLPPP encapsulation on the interface.
ALU(config-if <interface-name>)# encapsulation mlppp
<1-256>
Example:
ALU(config)#interface Serial1/0:0
ALU(config-if Serial1/0:0)# encapsulation mlppp 100
Step 16: Use “LFI - MLPPP Show Commands” to view the LFI configuration.