Link Fragmentation and Interleaving (LFI)
Left running head:
Chapter name (automatic)
448
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE FRAGMENT DELAY ON THE MLPPP INTERFACE
EXAMPLE
ALU(config)# interface mlppp 100
ALU(config-if mlppp100)# fragment delay 10
ALU(config-if mlppp100)# no fragment delay
Note: The MTU (Maximum Transmission Unit) of the individual links in a MLPPP bundle
should be greater than the fragment size.
Command (in ICM) Description
fragment delay <1-256> This command is entered in the Interface
Configuration mode.
This command is used to configure the
fragment delay on the MLPPP bundle
interface.
Fragment delay on the MLPPP interface
specifies how long it will take for a fragment
to exit the interface, in milliseconds. The
appropriate fragment size to meet the
specified serialization (fragment) delay is
automatically calculated.
The default value of fragment delay is 0,
i,e., no fragmentation will be performed.
no fragment delay The ‘no’ command sets the fragment delay
to default value and hence disables the
fragmentation on MLPPP.
To Next Page
Loading...
