Link Fragmentation and Interleaving (LFI)
Left running head:
Chapter name (automatic)
452
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
c) Configure QoS out policy on the interface.
ALU-1(config-if mlppp1)# service-policy out P1
d) Configure fragment delay and slippage MRU on the MLPPP interface
ALU-1(config-if mlppp1)#fragment delay 10
ALU-1(config-if mlppp1)#slippage mru 16
e) Configure Serial interface and set MLPPP encapsulation on the interface
ALU-1(config)#controller T1 0/0
ALU-1(config-controller T1)#channel-group 0 timeslots 1
ALU-1(config-controller T1)#exit
ALU-1(config)#
ALU-1(config)#interface Serial 0/0:0
ALU-1(config-if Serial0/0:0)#no shutdown
ALU-1(config-if Serial0/0:0)#encapsulation mlppp 1
On OA5740-B
a) Configure MLPPP bundle interface
ALU-2> enable
ALU-2#configure terminal
ALU-2(config)#interface mlppp 2
ALU-2(config-if mlppp2)#ip address 10.1.1.2/24
ALU-2(config-if mlppp2)#no shutdown
ALU-2(config-if mlppp2)#exit
ALU-2(config)#
b) Configure policy map. Associate match-list and class map with the policy map.
ALU-1(config)# match-list m2
ALU-1(config-match-list-m2)# udp any any
ALU-1(config)# class-map c2
ALU-1(config-qos-c2)# match m2
ALU-1(config)# policy-map P2
ALU-1(config-qos-P2)# class C2
c) Configure QoS out policy on the MLPPP interface.
ALU-1(config-if mlppp2)# service-policy out P2
d) Configure fragment delay and slippage MRU over the MLPPP interface
ALU-2(config-if mlppp2)#fragment delay 10
ALU-2(config-if mlppp2)#slippage mru 20
To Next Page
Loading...
