LFI Configuration on MLPPP
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
453
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
e) Configure Serial interface and set MLPPP encapsulation on the interface
ALU-2(config)#controller T1 0/0
ALU-2(config-controller T1)#channel-group 0 timeslots 1
ALU(config-controller T1)#exit
ALU-2(config)#
ALU-2(config)#interface Serial 0/0:0
ALU-2(config-if Serial0/0:0)#no shutdown
ALU-2(config-if Serial0/0:0)#encapsulation mlppp 2
Verification with Show Command
Verify the MLPPP configuration using the following command. The output from
this command not only shows fragment delay but also shows how many
fragmentation/ reassembly have been performed.
R2(config-if)# show interface mlppp 2
mlppp2 is up, line protocol is up
Internet address is 10.1.1.2/24
MTU 1494 bytes, BW 512 Kbit, DLY 0 usec,
reliability 255/255, txload 20/255, rxload 20/255
Encapsulation mlppp, loopback not set
IPCP: Open
Last input never, output never, output hang never
Last clearing of "show interface" counters never
2 packets input (2 Control packets, 0 Data packets), 28 bytes
2 packets output (2 Control packets, 0 Data packets), 28 bytes
0 packets dropped, 0 giants received
Fragmentation: Fragment Delay 10 ms
5 fragmented, 0 couldn't fragment
10 fragments created, 0x9 sent sequence
Reassembly: Slippage MRU 20
0 fragments in reassembly list
0 lost fragments, 0 reordered
11 discarded fragments, 0 reassembled
0 timeouts, 0 couldn't reassemble
0x10 received sequence
To Next Page
Loading...
