Protocol Independent Features
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
527
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO VIEW ROUTING TABLE
EXAMPLE 1
ALU# show ip route
Codes: R - RIP, O - OSPF, C - connected
S - static, M - mcstatic, B - BGP
IA - OSPF inter area route, E1 - OSPF external type 1 route,
E2 - OSPF external type 2 route, N1 - OSPF NSSA external type 1 route,
N2 - OSPF NSSA external type 2 route
* - candidate default route
Gateway of last resort is not set
5.0.0.0/24 is subnetted, 3 subnets
C 5.5.0.0 [0/0] is directly connected, Serial0/0:0
C 5.5.1.0 [0/0] is directly connected, Serial0/0:1
C 5.5.2.0 [0/0] is directly connected, Serial0/0:2
6.0.0.0 is variably subnetted, 2 subnets, 2 masks
S 6.6.6.0/24 [1/0] is directly connected, Serial0/0:2
O 6.6.6.6/32 [110/10][1] via 5.5.0.1, Serial0/0:0
via 5.5.1.1, Serial0/0:1
via 5.5.2.1, Serial0/0:2
S 7.0.0.0/8 [1/0] is directly connected, Serial0/0:0
is directly connected, Serial0/0:1
10.0.0.0/24 is subnetted, 1 subnet
C 10.91.2.0 [0/0] is directly connected, GigabitEthernet3/0
99.0.0.0/24 is subnetted, 1 subnet
C 99.99.99.0 [0/0] is directly connected, loopback1
S 100.0.0.0/8 [1/0] via 10.91.2.5, GigabitEthernet3/0
ALU#
Show Command (in SUM/CM) Description
show ip route [{network-
number|ip-address/prefix
length} [longer-prefixes]
|ospf [<1-65535>]
|connected|bgp|rip
|summary|supernets-only|vrf
<vrf-name>]
Displays the current state of a routing
protocol.
You can filter show IP route output to view
specific protocol routes.
To Next Page
Loading...
