Alcatel-Lucent OmniAccess 5740 - Page 571

RIP Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
545
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
RIP AUTHENTICATION
Note: RIP Version 1 does not support authentication.
If you are sending and receiving RIP Version 2 packets, RIP authentication on an
interface can be enabled. The key chain determines the set of keys that can be
used on an interface. If a key chain is not configured, no authentication is
performed on that interface, not even the default authentication.
We support two modes of authentication on an interface for which RIP
authentication is enabled: Plain Text Authentication and MD5 Authentication.
The default authentication in every RIP Version 2 packet is Plain Text
Authentication.
The OmniAccess 5740 USG implementation of RIPv2 message authentication
includes the choice of simple password or MD5 authentication and the option of
defining multiple keys, or passwords, on a "key chain".
T
O CONFIGURE KEY CHAIN
EXAMPLE
ALU(config)# key-chain allen
ALU(config-keychain allen)#
T
O CONFIGURE A KEY
EXAMPLE
ALU(config-keychain allen)# key 100
ALU(config-keychain-key 100)#
Command (in CM) Description
key-chain <key-chain name> This command is used to configure a key
chain.
Command (in Key-chain Mode) Description
key <0-2147483647> This command is used to configure a key
that can be used on an interface in the
range 0-2147483647.