Alcatel-Lucent OmniAccess 5740 - Page 572

Routing Information Protocol
Left running head:
Chapter name (automatic)
546
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE A KEY PASSWORD
EXAMPLE
ALU(config-keychain-key 100)# key-string sg123
T
O ENABLE RIP AUTHENTICATION ON AN INTERFACE
To enable RIP authentication, authentication key chain and authentication mode
should be configured on the interface.
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# ip rip authentication key-
chain allen
ALU(config-if GigabitEthernet3/0)# no ip rip authentication
key-chain allen
Command (in Key-chain Key Mode) Description
key-string <key string> This command is used to configure the
password for the key.
Command (in ICM) Description
ip rip authentication key-
chain <key-chain name>
Use the following command in the
Interface Configuration mode.
This command is used to associate a key
chain to an interface. This enables RIP
authentication.
no ip rip authentication key-
chain <key-chain name>
The ‘no’ command removes the key
chain associated to an interface. This
disables RIP authentication.