Alcatel-Lucent OmniAccess 5740 - Page 676

Policy Based Routing
Left running head:
Chapter name (automatic)
650
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O ATTACH / DETACH AN IP POLICY TO AN INTERFACE
EXAMPLE
The following example binds the IP policy ‘pbr1’ to interface GigabitEthernet3/1:
ALU(config)# interface GigabitEthernet3/1
ALU(config-if GigabitEthernet3/1)# ip-policy pbr1
If the IP policy pbr1 is attached to the GigabitEthernet3/1, the following command
detaches it from the interface:
ALU(config)# interface GigabitEthernet3/1
ALU(config-if GigabitEthernet3/1)# no ip-policy pbr1
Command (in ICM) Description
ip-policy <ip-policy name> This command is used to attach an IP
policy to an interface.
Note: You cannot apply the IP
policy on the interface
having a Transparent
Forward policy. Remove
the TF policy before
configuring the IP policy.
no ip-policy <ip-policy name> This command detaches the IP policy
attached to an interface.