VRF-CE Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
669
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
ALU(config)# show arp traffic vrf ALU-vrf
ARP Traffic statistics:
Request Recvd :0 Request Sent :6
Response Recvd :1 Response Sent :0
Rate limiting:
Request Not Answered :0
Request Not Sent: 0
ADJ count exceeded :0
Errors:
Req/Resp recvd without Mac on interface :0
Req not sent because of no IP Address :0
Req not sent becuase of no MAC :0
Resp received without req :0
T
O ASSOCIATE A VRF TO AN INTERFACE
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip vrf forwarding ALU-vrf
Command (in ICM) Description
ip vrf forwarding <vrf-
name>
Enter this command in the Interface
Configuration Mode.
This command is used to associate a VRF to
an interface.
Note: IP address configuration on the
interface is removed when this
command is executed. Hence,
configure the IP address after
associating a VRF to an
interface.
To Next Page
Loading...
