Network Address Translation
Left running head:
Chapter name (automatic)
692
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O REORDER THE RULES IN SNAT
Note: Rule/line numbers will not be shown unless you specifically type them in. Also, the line
numbers can be seen only in the “show” command.
Note: Refer to the “Updations” section to know more on the “change” and “renumber”
keywords.
E
XAMPLE
ALU(config-nat-N1)# renumber
ALU(config-nat-N1)# change 10 20
Command (in NCM) Description
renumber Use this command to generate a
numbering scheme for the SNAT
rules configured. This command
resets the rule priorities in multiples
of 10.
change <1-65535> <1-65535> Use this command to change the
priority/order of a specific SNAT rule
configured.
To Next Page
Loading...
