Network Attack Prevention Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
759
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
To view firewall policy configuration after renumbering, use the show command.
The output appears as shown:
show firewall policy P1
ip policy P1
10 match m1 attack atk drop
20 match m4 attack atk drop
30 match m2 attack atk reset
40 match m3 attack atk reset
T
O ATTACH A FIREWALL POLICY TO AN INTERFACE
Note: Firewall policy will take into effect once it is attached to an interface.
E
XAMPLE
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)# firewall policy in P1
Command (in ICM) Description
firewall policy {in|out} <policy-
name>
This command is used to attach a
firewall policy to an interface in ‘in’ or
‘out’ direction.
Firewall policy is applied to the
ingress (incoming) traffic if “in”
keyword is used.
Firewall policy is applied to the
egress (outgoing) traffic if “out”
keyword is used.
To Next Page
Loading...
Need help?
General
