Alcatel-Lucent OmniAccess 5740 - Page 905

IPsec Tunnel Interface Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
879
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO ATTACH AN IKE IDENTITY TO AN IPSEC PROFILE
Note: IKE identity should only be attached to an IPsec profile if the Authentication type is
‘rsa-sig’
E
XAMPLE
ALU(ipsec-profile-PF1)# ike-identity ID01
ALU(ipsec-profile-PF1)# no ike-identity
T
O CONFIGURE A TUNNEL INTERFACE
EXAMPLE
ALU(config)# interface Tunnel 1
ALU(config-if Tunnel1)#
T
O ADMINISTRATIVELY BRING UP/SHUTDOWN THE TUNNEL INTERFACE
EXAMPLE
ALU(config-if Tunnel1)# no shutdown
ALU(config-if Tunnel1)# shutdown
Command (in IPsec Profile CM) Description
ike-identity <name> This command attaches an IKE identity to
an IPsec profile.
no ike-identity The ‘no’ command detaches the specified
IKE identity attached to a profile.
Command (in CM) Description
interface Tunnel <0-14487> This command is used to configure a
tunnel interface.
Command (in ICM) Description
no shutdown This command is used to
administratively bring up the tunnel
interface.
shutdown This command is used to
administratively bring down the tunnel
interface.