IP Security - Virtual Private Network
Left running head:
Chapter name (automatic)
880
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE IP ADDRESS ON A TUNNEL INTERFACE
EXAMPLE
ALU(config-if Tunnel1)# ip address 20.20.20.20/24
ALU(config-if Tunnel1)# ip address 192.168.0.1 255.255.255.255
T
O CONFIGURE MODE ON A TUNNEL INTERFACE
EXAMPLE
ALU(config-if Tunnel1)# mode ipsec
Command (in ICM) Description
ip address {<ip-address
subnet-mask>|<ip-address/
prefix-length>}
This command is used to assign an IP
address and subnet mask to the tunnel
interface.
Command (in ICM) Description
mode {gre|ipsec} This command is used to set the mode
on tunnel interface.
To configure IPsec tunnel interface, set
the mode to IPsec.
Note: By default, tunnel is
configured in GRE mode.
To Next Page
Loading...
