Alcatel-Lucent OmniAccess 5740 - Page 907

IPsec Tunnel Interface Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
881
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO CONFIGURE SOURCE IP ADDRESS FOR THE TUNNEL
EXAMPLE
ALU(config-if Tunnel1)# tunnel source 2.2.2.1
or
ALU(config-if Tunnel1)# tunnel source GigabitEthernet3/0
ALU(config-if Tunnel1)# no tunnel source 2.2.2.1
or
ALU(config-if Tunnel1)# no tunnel source GigabitEthernet3/0
T
O CONFIGURE DESTINATION IP ADDRESS FOR THE TUNNEL
EXAMPLE
ALU(config-if Tunnel1)# tunnel destination 2.2.2.3
ALU(config-if Tunnel1)# no tunnel destination 2.2.2.3
Command (in ICM) Description
tunnel source {<ip-address>|
<interface-name>}
This command sets the source IP
address of the tunnel.
no tunnel source {<ip-address>
|<interface-name>}
The “no” command removes the
configured source IP address of the
tunnel.
Command (in ICM) Description
tunnel destination <ip-
address>
This command sets the destination IP
address of the tunnel at the remote end.
no tunnel destination <ip-
address>
The “no” command removes the
configured destination IP address.