IP Security - Virtual Private Network
Left running head:
Chapter name (automatic)
882
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O ATTACH AN IPSEC PROFILE TO THE TUNNEL INTERFACE
IPsec Profile needs to be applied to the IPsec tunnel interface through which the
IPsec traffic flows.
Binding an IPsec profile to an interface instructs the system to evaluate all the
interface traffic against the IPsec profile, and to use the specified policy during
connection or security association negotiation.
E
XAMPLE
ALU(config-if Tunnel1)# ipsec-profile PF1
ALU(config-if Tunnel1)# no ipsec-profile PF1
Command (in ICM) Description
ipsec-profile <profile-
name>
Enter this command in the Tunnel Interface
Configuration Mode.
This command is used to attach the
configured IPsec profile to the tunnel
interface.
no ipsec-profile <profile-
name>
This command is used to detach the IPsec
profile attached to the interface.
Note: You cannot delete an IPsec
profile that is applied to the
interface. To delete, first detach
the IPsec profile from the tunnel
interface.
To Next Page
Loading...
