Generic Routing Encapsulation
Left running head:
Chapter name (automatic)
948
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE DESTINATION IP ADDRESS FOR THE TUNNEL
EXAMPLE
ALU(config-if Tunnel7)# tunnel destination 10.1.0.5
ALU(config-if Tunnel7)# tunnel destination mysmb.dyndns.org
ALU(config-if Tunnel7)# no tunnel destination 10.1.0.5
ALU(config-if Tunnel7)# no tunnel destination mysmb.dyndns.org
T
O SET THE TUNNEL DF-BIT
E
XAMPLE
ALU(config-if Tunnel7)# tunnel df-bit clear
Command (in ICM) Description
tunnel destination {<ip-
address>|<FQDN>}
This command sets the destination IP
address or fully qualified domain name
(FQDN) of the tunnel at the remote end.
no tunnel destination {<ip-
address>|<fqdn>}
The “no” command removes the
configured destination IP address or
FQDN of the tunnel.
Command (in ICM) Description
tunnel df-bit {clear|set|copy-
from-inner-ip}
This command sets the value of the DF-
bit for the Outer-IP header.
The default DF-BIT value is ‘clear’.
To Next Page
Loading...
Need help?
General
