EasyManua.ls Logo

Burkert FLOWave L - Page 234

Burkert FLOWave L
354 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
234
SAW sensor – Parameter
Type 8098 FLOWave L
 
Special event in the process  Special condition
Nottotallylled 
If the parameter Refreshtime is set to
Veryshort, the event Nottotallylled
cannot be monitored.
Not all the sensors are in contact
with the liquid.
Liquidoutofrange The speed of sound in the liquid is out
of range.

of sound in the liquid is lower



above: The speed of sound in


Unstableow  
rate measurements is too high.
Lowowcuto 
been used.



.
Changeofliquid 

display.
The speed of sound in the liquid


Backwardow 
direction as the one set in

.
-
 
Special event occurring on the
sensor
 Special condition
Soundcond.outofrange There are gas bubbles or solid
particles in the liquid.
-
 
Special event occurring on the
electronics
 Special condition
Output1,openloop There is a connection problem on the
related output.
The related analogue output must

Disabling an analogue output
Output3,openloop
Output1,Diag.error There is a connection problem on the
related output or a high resistance is
detected in the loop.
The related analogue output must

Disabling an analogue output.
Output3,Diag.error
Output2overload An overload has been detected on the
related digital output.
The output has switched.
-
Output3overload
English

Table of Contents

Related product manuals