Burkert FLOWave L - Page 235

235
SAW sensor – Parameter
Type 8098 FLOWave L
→ Do the settings for a special event (see
, ,  and ).
Is the event associated to the device
status None?
Yes
The event is disabled.
No
Is the event associated to the device
status Normalstate

?
Yes
• The event cannot be signalled by an
analogue output.
• If the event is enabled, a message is
generated if the event occurs.
No
→ Choose the behaviour of the analogue output(s)
for each device status (Failure, Outofspeci-
cation and Maintenancerequired).

.
No
The event cannot be signalled by a
digital output.
Yes
If the event is enabled, it can be signalled by a digital output


• depending on this single event.
• and/or, depending on Failure, Outofspecication or Main-
tenancerequired events.
→ Activate the Diagnostics in Generalsettings –
PARAMETER.
 

Normalstate means that only a message is generated when the event occurs but the event is considered to be part of the normal
operating of the process, or of the electronics, or of the sensor.
English