462 EDIUS — User Reference Guide
Section 5 — Timeline Operations
Clip In
Place clips on tracks based on the In point timecode of each clip. If no In
point is set for the clip, the beginning of the clip is used.
Clip Out
Place clips on tracks based on the Out point timecode of each clip. If no Out-
point is set for the clip, the end of the clip is used.
2. Select a V/VA track on which to place clips.
3. Select multiple clips in the Asset Bin and click the Add to Timeline
button as illustrated in Figure 524.
Note Selected clips may also be dragged and dropped on the Timeline.
Figure 524. Add Multiple Clips to Timeline
Clips are placed on tracks according to the selected sync point.
Note If “Asynchronous” was selected as the sync point in Step 1 above, all clips
are placed on the selected track. If a different sync point is selected, the clips
are placed on the selected track and the tracks above the selected track. If
there are no tracks above the selected track, new track(s) are added.
The camera switch point is automatically set to the In/Out points of each
clip. See Setting Camera Switch Point During Playback on page 469 for infor-
mation in changing the camera switch point.
Placing multiple clips on the Timeline in multi cam mode results in a
Recorder window display similar to that shown in Figure 525.
To Next Page
Loading...
Need help?
General