EDIUS — User Reference Guide 719
EDIUS SP/SP-SDI (SHX) Settings
16. Select the desired setup level (black level) from the “Setup Level” drop-
down list.
Note 0 IRE is commonly used in Japan and 7.5 IRE is commonly used in North
America.
17. Select the desired component level from the “Component ” drop-down
list.
18. Set the gain control as desired by selecting “Manual” or “Auto” from
“Gain Control” drop-down list and adjusting the Gain Control slider.
Gain Control adjusts the image brightness. When set to ‘Auto” lumi-
nance is automatically adjusted to the optimum level. When set to
“Manual,” luminance is adjusted manually.
19. From the “Audio Mapping” drop-down list, select “Balanced” or
“Unbalanced” audio as desired.
Note This option is not available on all hardware devices.
20. From the “Control Mapping” drop-down list, select “RS422 REMOTE”
if you wish to enable remote control through the RS422 serial port.
Note This option is not available in all hardware devices.
21. Select the “Use TC Input Terminal” option if you want to use the
timecode terminal for remote control.
Note This option is not available in all hardware devices.
22. Click the OK button to save the changes and close the Input Settings
dialog.
While in the Input Settings dialog or any of the Image Adjustment Settings
dialogs, clicking the
Default* button returns all settings marked with an “*”
to their default values.
Canopus HQ Codec Settings
To define Canopus HQ Codec Settings for any hardware device, do the fol-
lowing:
1. If necessary, click the “+” to expand the settings tree for the device.
2. Select “Canopus HQ Codec Settings” from the settings tree. A dialog
similar to that in Figure 869 appears.
To Next Page
Loading...
Need help?
General