EDIUS — User Reference Guide 713
EDIUS SP/SP-SDI (SHX) Settings
7. Select the “Enable Wide Screen Signaling” if content is to be displayed
on televisions that support WSS with automatic aspect ratio (4:3 or 16:9)
switching.
8. Set the desired Balanced Audio Settings for “Input Headroom [dB]”,
“Input Level [dBu]”, “Output Headroom [dB]”, and “Output Level
[dBu]” by selecting the desired setting from the associated drop-down
lists.
For SXH-E1, proceed to Step 11.
Note Step 9 and Step 10 apply to SHX-E2 hardware only.
9. From the “Analog Audio Monitoring” drop-down list box, select the
desired channel for audio monitoring. Choices are: Ch 1/2, Ch 3/4 or
Ch 1+3/2+4.
10. If applicable, select the two VBI lines on which VITC (vertical interval
timecode) data is present. Typically, this is lines 14 and 16 for NTSC and
lines 19 and 21 for PAL video.
11. Click the OK button to save the settings and close the General I/O
Settings dialog.
While in the General I/O Settings dialog, clicking the
Default* button
returns all settings marked with an “*” to their default values.
DV Device Settings
1.If necessary, click the “+” to expand the SHX-E1/SHX-E2 Settings tree.
2.Select “DV Device Settings” from the SHX-E1/SHX-E2 Settings tree. The
dialog in Figure 864 appears.
To Next Page
Loading...
Need help?
General