Schweitzer Engineering Laboratories SEL-751 - Page 420

SET.48
of 78
SEL-751 Settings Sheets Date________________
SET PORT p (p = F, 1, 2, 3, or 4) Command PORT 1
SEL-751 Relay Instruction Manual Date Code 20170927
Session 3
(All Session 3 settings are hidden if EDNP < 3)
Misc Data Reporting Dead-band Counts (0–32767)
(Hidden if ECLASSA2 := 0 and ECLASSC2 := 0) ANADBM2 :=
Minutes for Request Interval (I, M, 1–32767) TIMERQ2 :=
Seconds to Select/Operate Time-Out (0.0–30.0) STIMEO2 :=
Seconds to send Data Link Heartbeat (0–7200) (HiddenifDNPTR2:=UDP) DNPINA2 :=
Event Message Confirm Time-Out (1–50 s) ETIMEO2 :=
Enable Unsolicited Reporting (Y, N) (Hidden if ECLASSA2 := 0, ECLASSB2 := 0,
ECLASSC2 := 0, and ECLASSV2 := 0) UNSOL2 :=
Enable Unsolicited Reporting at Power-Up (Y, N) (Hidden if UNSOL2 := N) PUNSOL2 :=
Number of Events to Transmit On (1–200) (Hidden if UNSOL2 := N) NUMEVE2 :=
Oldest Event to Tx On (0.0–99999.0 s) (HiddenifUNSOL2:=N) AGEEVE2 :=
Unsolicited Message Max Retry Attempts (2–10) (HiddenifUNSOL2:=N) URETRY2 :=
Unsolicited Message Offline Time-Out (1–5000 s) (HiddenifUNSOL2:=N) UTIMEO2 :=
DNP Master IP Address {zzz.yyy.xxx.www} (15 characters) DNPIP3 :=
Transport Protocol (UDP, TCP) DNPTR3 :=
UDP Response Port (REQ, 1–65534) DNPUDP3 :=
DNP Address to Report to (0–65519) REPADR3 :=
DNP Map (1–3) DNPMAP3 :=
Analog Input Default Variation (1–6) DVARAI3 :=
Class for Binary Event Data (0–3) ECLASSB3 :=
Class for Counter Event Data (0–3) ECLASSC3 :=
Class for Analog Event Data (0–3) ECLASSA3 :=
Currents Scaling Decimal Places (0–3) DECPLA3 :=
Voltages Scaling Decimal Places (0–3) DECPLV3 :=
Misc Data Scaling Decimal Places (0–3) DECPLM3 :=
Amps Reporting Dead-band Counts (0–32767) (HiddenifECLASSA3:=0) ANADBA3 :=
Volts Reporting Dead-band Counts (0–32767) (HiddenifECLASSA3:=0) ANADBV3 :=
Misc Data Reporting Dead-band Counts (0–32767)
(Hidden if ECLASSA3 := 0 and ECLASSC3 := 0) ANADBM3 :=
Minutes for Request Interval (I, M, 1–32767) TIMERQ3 :=
Seconds to Select/Operate Time-Out (0.0–30.0) STIMEO3 :=
Seconds to send Data Link Heartbeat (0–7200) (HiddenifDNPTR3:=UDP) DNPINA3 :=
Event Message Confirm Time-Out (1–50 s) ETIMEO3 :=
Enable Unsolicited Reporting (Y, N) (Hidden if ECLASSA3 := 0, ECLASSB3 := 0,
ECLASSC3 := 0, and ECLASSV3 := 0) UNSOL3 :=
Enable Unsolicited Reporting at Power-Up (Y, N) (HiddenifUNSOL3:=N) PUNSOL3 :=
Number of Events to Transmit On (1–200) (Hidden if UNSOL3 := N) NUMEVE3 :=
Oldest Event to Tx On (0.0–99999.0 s) (HiddenifUNSOL3:=N) AGEEVE3 :=
Unsolicited Message Max Retry Attempts (2–10) (HiddenifUNSOL3:=N) URETRY3 :=
Unsolicited Message Offline Time-Out (1–5000 s) (HiddenifUNSOL3:=N) UTIMEO3 :=